The Atwood furnace thermostat
This paper will discuss how to troubleshoot an Atwood furnace and the common problems that users might face.
The Atwood furnace thermostat is arguably one of the most commonly used products today. The device is purported to be a heating appliance but also functions as a thermostat. It has a built-in heat sensor and temperature regulator, which detects temperature changes in the room and keeps it at an optimum level to maintain comfort during winter. This device helps in providing comfortable heating throughout the day without much effort for users.
A common problem faced by users with this product is not detecting when it heats up or when the room gets too hot and shuts itself down abruptly.
It’s important to know how to troubleshoot this issue to avoid it from happening again in the future, making your heating experience more comfortable than ever before!
When your Atwood furnace starts showing signs of trouble and is not responding properly, you have to follow these steps to get it working again:
– Turn off the power switch located in the furnace.
– Remove screws and pull off the cover plate on the control unit.
– Disconnect power supply wires from the control unit.
– Unplug the “thermostat” plug and remove the wires.
– Remove all connections one by one and connect them back together correctly.
– Connect the thermometer wire back into place correctly by twisting twice as close as possible without breaking any connections. At the same time, the battery is still disconnected from the thermostat (If your thermostat has a battery compartment).
The Atwood error code indicates problems with the furnace’s electronic control system. A three-digit number follows the error code.
The first digit indicates the type of problem, while the second and third digits indicate the specific cause.
If you are experiencing Atwood error codes, you can look up troubleshooting instructions in your furnace manual in case you don’t know what’s going on with your unit!
“Inspections, Installations, Repairs & Maintenance”