Amana furnace 06 error code

Amana furnace 06 error code is usually due to a faulty thermostat.

If the thermostat fails, then the Amana 06 error code will be set and it will not allow the furnace to operate. The user must contact an Amana customer service agent or technician for assistance with this matter.

Amana furnace 06 error code is an error code that can be displayed on your Amana unit. This error code is generated when the electronic ignition system goes bad and needs to be replaced with a newer one.

Amana is a well-known company for its quality heating and cooling products. The company has been around for over 50 years, and so the quality of its products is among the best in the industry.

The Amana furnace 06 error code indicates that there is an issue with either the high limit control or cycling mode. If no issue can be found after full testing, it would need to be replaced. In this case, it’s possible that a blown thermal fuse or wire may have caused this error code.

Error code 06 is an error of a safety system failure.

If you see this error code on your furnace, the most likely cause is that your installation’s circuit breaker tripped or the furnace power cord was pulled out of the outlet.

In this case, turn off and unplug your furnace, wait 10 minutes and plug it back in before turning it on again. If the problem persists, contact your local HVAC contractor.

Amana furnace 06 error code: The error code 06 is an error of a safety system failure

How to fix Amana furnace 06 error code: Turn off

Amana furnace 06 error code is one of the common errors that the furnace may show because it can indicate a number of problems. These errors will also vary according to the type of Amana furnace, which is why it is important to consult with a technician.

This article will provide information on what the Amana furnace 06 error code means and how to troubleshoot and fix it.

Amana has been a trusted name in the home appliance industry for over 100 years. The company was established by George Foerstner in the year 1892 and built its reputation by engineering high-quality heating products that could withstand harsh weather conditions.

The Amana furnace 06 error code arises when the igniter is not working as expected. The problem can be caused due to several reasons. There may be a clog of soot on the coil or it could also be a faulty gas valve assembly. But before you run to call an Amana-certified service technician just give your furnace a chance to recalibrate itself once after you have turned it off for a few minutes or hours.