Amana furnace error code p1

In a furnace, the heating process is initiated by burning fuel to generate heat. This heat is then transferred to the metal surfaces of the furnace through convection and radiation. The metal surfaces are heated, while they also radiate some of the energy back into the system. When metal reaches a critical temperature, it begins to glow red or white-hot.

This P1 code indicates that there is a high-limit protection fault with the Amana furnace or that something has gone wrong with it.

Amana is a manufacturer of home and commercial heating, cooling and cooking products. The company has been around since 1881 and is headquartered in Evansville, Indiana.

The most common Amana Error Codes are P1 and P2. These errors indicate that the furnace needs to be cleaned. The instructions for resetting these error codes can be found below:

1) Turn off all the power to the furnace by pulling the breaker to the unit or turning it off at a nearby switch box or circuit breaker panel. You may also disconnect power from a nearby plug strip if you want to be extra sure that your furnace won’t turn on accidentally. 2) Take out the two screws holding the access panel in place (near where your air conditioner goes).

This error code is an indication that there is a problem with the electronic input sensor.

So what should you do if you have this error code on your machine? You need to call a technician for help. He will be able to fix the problem and get your furnace up and running again.