The furnace is not working.
With this furnace, the user can connect to their smart home to automatically control and monitor the system.
When the furnace is not working, and you’re faced with the “no codes” error message, it can seem like there’s no way to fix your furnace. This isn’t true because there are a few things you can try that may help get you back up and running again.
There are two techniques for fixing your problem when a thermocouple gets stuck in an open circuit:
1) Using a jumper wire or small piece of metal between the circuit board pins on the thermostat, or
2) Using electrical tape on top of the thermostat cover.
—
This is an example of a furnace not working.
The most common causes for this are:
-A burnoff switch was tripped, likely because of a lack of clean air in the system
-The thermostat is incorrectly set and needs to be reset
-Condensate drain line clogged with debris
-Drainage line clogged with sludge
The furnace is not working, but there are no codes in the control panel. What could be the problem?
You may have a blown a fuse or a burned-out pilot light in the circuit board. You can also check to see if you have any outdoor lights that are off and should be on.
“Inspections, Installations, Repairs & Maintenance”
