Armstrong furnace pilot light

It is important to know how to light the pilot light on the Armstrong furnace in order to ensure the safety of the home.

This procedure should be done before operating any other controls because it will not work if power is not turned on.

There are two ways that the pilot can be lit. The first way is by using a remote control device and the second way is by turning on the power at the furnace circuit breaker. This procedure should be done before operating any other controls because it will not work if power is not turned on.

The pilot light on an Armstrong furnace is a small flame that is used to ignite the burners when the furnace needs to be lit.

In this article, we will show you how to light the pilot light on an Armstrong furnace. First, check if your main gas distributor valve is set to “On”. Then, turn off all of your household gas appliances and close all gas shut-offs. Open one exterior door and allow natural ventilation for 5 minutes before turning on the gas again.

I was told by a friend that the pilot light on their Armstrong furnace is not working and they can’t seem to figure out how to light it. After checking the manual, I found out that there are a couple of things you can do to get the pilot lit.

– Check if there is any obstruction in the gas line and make sure it is connected properly

– Check if the thermostat is set on any heating mode other than “pilot”

– Switch off the power supply and wait for 5 minutes before switching back on

“Inspections, Installations, Repairs & Maintenance”