Luxaire furnace error code 7 flashes
There may be different causes for the Luxaire furnace error code 7 flashes. It could be due to an update that has been performed that was not properly completed, a programming error, or a defective component.
While there are more than likely multiple causes for the Luxaire furnace error code 7 flashing, it is important to have it inspected by an experienced technician who can diagnose and repair the issue.
—
Luxaire furnace error code 7 flashes refer to a specific error code that appears on the Luxaire model series. The error code indicates that the system control board is not properly communicating with the heating and air conditioning system.
The error code is caused by a faulty wiring harness near the control board. The wiring harness can get damaged from falling objects, water leaks, power surges, or physical damage from an accident. If this happens, then your furnace will continue to work but will be unable to provide you with consistent levels of temperature.
The common symptoms of luxaire furnace error code 7 flashes are inaccurate temperatures, frequent cycling on and off, intermittent lack of heating or cooling flow when it should be flowing smoothly as well as longer times for hot air to reach rooms in your house.
—
When this code flashes, it indicates that there is a problem with the heat exchanger of the furnace. This means that there might be a leak and some gas could escape.
The possible problems with the furnace are:
– A loose cable or connection to the controller
– A vent or flue that’s not connected properly
– An inoperative sensor