Viessmann boiler error 51

This is to provide you with a solution for viessmann boiler error 51.

Viessmann boilers use a programmed pilot light to provide the initial ignition source for gas burners under various circumstances.

In a nutshell, this is what you should know if your Viessmann boiler comes with an error 51.

One of the most frequent errors on Viessmann boilers is error 51, which happens to be the most common issue that can happen in the heating system. This error is usually caused by faulty ignition devices, and the best thing you can do when it comes up is to replace them.

Viessmann Boiler Error 51 is one of the most common boiler problems and can be easily fixed.

Boiler error code 51 shows up when an overheat sensor detects that the water in your boiler has been heated to a temperature exceeding 240 degrees Fahrenheit. It might be a symptom of a defective heating element. The solution to this problem is to replace your heating element with a new one by following these steps:

– Shut off the power supply

– Unplug the unit

– Remove the cover by unscrewing four screws on each side of the unit, two at the top and two at the bottom, then sliding it up and out

– Underneath, you will see some sensors and gas control valve wiring. Disconnect all wires from their attached terminals to remove them from their sockets – Unscrew one screw on either side of each sensor wire connector, releasing enough slack so that you can pull it away but not too much so that

“Inspections, Installations, Repairs & Maintenance”