Viessmann boiler error code 9e

The boiler error code 9e is due to the boiler over-filling.

All boilers have a built-in safety mechanism that should stop the boiler from operating if it overfills and cause an overflow, but this may fail from time to time.

This error code can also be caused by a faulty pressure sensor or a faulty solenoid valve, according to viessmann.

The error code 9E indicates that the hot water temperature is not in the desired range.

The error code 9E indicates that the hot water temperature is not in the desired range, so you should check if it’s too low or too high. On a Viessmann boiler, the thermostat may be set incorrectly.

This site is a viessmann boiler error code 9e to help us to solve the problem.

If your boiler shows the error code 9E, it indicates a problem with the gas valve.

This fault is usually because of a blocked or incorrectly set gas supply. This can happen when a filter has been fitted to the incoming gas pipe, which blocks the gas flow. It’s also possible that an incorrect pipe or tap connection has been made at the main supply housing.

A blocked or unclear venting system can also trigger this problem. This can be caused by leaves and dirt collecting on rooftops and blocking vent pipes between homes. These pipes could also be cracked, which means that warm air cannot get out of them properly and instead gets trapped inside.

“Inspections, Installations, Repairs & Maintenance”