Financing Available | 12 Months & No Interest

Mail us on

info@RomaHeating.ca

Carrier furnace error light codes

Book Your Appointment Now!

To book your next HVAC appointment with us, simply fill out the form below and we’ll contact you shortly. Alternatively, you can call the numbers listed on our website.

Carrier furnace error light codes

Carrier furnace error light codes

 

How do you read a carrier furnace error code?

Carrier Furnace Error Codes
Each status code is a two-digit number. The first number is determined by the number of short flashes and the second digit by the number of long flashes. Line voltage polarity is reversed. If twinned, refer to twinning kit instructions.

What does it mean when your furnace light is blinking?

If you realize that a solitary light blinking slowly and the other flashing quickly, your heating system could be experiencing a low flame signal. This can take place even when your furnace is heating correctly. It signifies the flame sensing rod could be dirty or in the incorrect location on the burner.

Where is the carrier furnace reset button?

Press and release the raised red button at the center of the flame roll-out switch to reset the furnace. You can press the reset button up to three times before troubleshooting the furnace’s internal components or calling for repair service; allow 30 minutes between each reset.

Is there a reset button on a carrier furnace?

Press and release the raised red button at the center of the flame roll-out switch to reset the furnace. You can press the reset button up to three times before troubleshooting the furnace’s internal components or calling for repair service; allow 30 minutes between each reset.

What is 13 limit lockout carrier?

13 is limit circuit lockout, in which case your furnace would try and restart after 3 hours. The limit circuit is there to protect the furnace from overheating if there is insufficient airflow through the heat exchanger taking the heat away from the furnace and pushing it into your ductwork.

What does a yellow blinking light mean on a carrier furnace?

If you see 1 amber/yellow flash, this means that everything is okay and the thermostat is signaling the need for cooling. If 4 amber/yellow flashes appear on your York Furnace, it means that the heating of your system may be somewhat restricted.

Why is yellow light flashing on my furnace?

What it means: If you’re wondering, “What does the yellow light on my Carrier furnace mean?” it signifies that the furnace is stuck in high-fire mode. The high-fire mode should only operate for short periods of time to heat a very cold house faster.

How do I know if my furnace fuse is blown?

If the voltmeter reads nothing on this side, the problem is not with the fuses. Test the outgoing voltage. After testing the incoming wires, connect the voltmeter’s leads to the load wire’s lugs. If you have a zero volt reading, then you know you have a blown fuse.

How do you troubleshoot a carrier furnace?

Gas Furnace Troubleshooting
Check the thermostat to ensure it is getting power. Those that aren’t hardwired into your home use batteries that may need to be replaced. Check that the fan switch is turned to the “on” or “auto” setting. Check the circuit breaker to ensure the furnace is still getting power.

Why does my Bryant furnace keep shutting off?

If your furnace keeps shutting off, it could be due to low airflow. There are several indirect issues that cause low airflow. Dirty Air Filters. If you don’t change your air filters often enough, the filters will become dirty and clogged, which means the heat exchanger retains heat and eventually causes it to overheat.

Why is my furnace running but no heat?

Furnace filters
Dirty filters are the most common cause of furnace problems. Dust and dirt restrict airflow—and if the filter gets too clogged, the heat exchanger will overheat and shut off too quickly, and your house won’t warm up. If the blower is running but no heat is coming out, replace the filter.

Carrier furnace error light codes 1

ROMA™ | 20 Years Trust

Most Trusted Heating Service in BC

We covert the following areas:

we serve all major metropolitan areas and more

with over 25 Certified technicians in the field every day

24/7 Emergency Services


Vancouver

Book Your Appointment Now! 📅

To book your next HVAC appointment with us, simply fill out the form below and we’ll contact you shortly. Alternatively, you can call the numbers listed on our website.

How can we help you ?
By submitting this form, I agree to the terms and conditions.