Lennox furnace error code XP25
Lennox furnaces offer customers a variety of energy-saving and energy-efficient options.
The Lennox XP25 error code is a common furnace error code. The Lennox XP25 error code typically means low or high voltage to the furnace control board. An issue can cause this with the power supply or a bad connection on the wires going to the furnace controller board.
The most common cause of this error is a power outage, fluctuation, or a lost connection on the wires going to the house disconnect. Still, it can also be caused by failure of the power supply, bad connections on either side of the contactor, a defective thermostat, shorted thermostat contacts, shorted safety thermostat contacts, and defective transformer in blower motor assembly.
The Lennox XP25 is a furnace producing between 80,000 and 140,000 BTUs.
If you are experiencing an issue with your Lennox XP25 furnace and you’re not sure which error code it is displaying
You might have to head to the Lennox website for more information because all their error codes can be found there.
Let’s look at some of the most common errors for this model:
– Error Code P01: This is a power failure error message that displays when the furnace has lost power completely. It will display this message for a few minutes before shutting off, and it cannot be reset without restarting the system from its website. If you are getting this error code on your unit, it means there’s been some sort
Error code xp25 is an error that occurs in the Lennox home heating and cooling system. This Lennox furnace error code can be caused by a faulty or incorrectly installed blower motor.
It is recommended that the user consult a service professional before proceeding with any repairs. Several other factors can cause this Lennox furnace error code xp25, and the user can make the problem worse rather than resolve it.
“Inspections, Installations, Repairs & Maintenance