Viessmann boiler vitodens error 80
A vitodens error 80 is a fault on some of the newer models of viessmann boilers. The error code is caused when a timer fails and sends the wrong signal to the boiler’s control board.
The repairs for this error are fairly simple because they can be fixed in less than 30 minutes. All that needs to be done is resetting the timer, which you will find at the back of your boiler.
The error code 80 usually happens when the boiler is not connected to the mains water supply. There can be several reasons for that:
– The mains water supply is too high, so it cannot go over the heating element
– The heating element is defective
– Cut off valve of the gas pipe is open, so gas cannot enter to heat the water
– The gas pipe is broken and needs replacing
This is a technical error that appears on the screen of the boiler. It is generally displayed when the boiler is blocked, either due to a power failure, lack of hot water in pipes or overflow of water. The solution to this problem is to reset the software.
Viessmann boiler vitodens error 80 is the most common problem that this kind of device has.
It is not a surprise that these devices are associated with malfunctions, not just because they’re old but because they require more maintenance.
Error 80 is due to a problem with the water or heat exchanger.
Viessmann boiler model vitodens error 80 can be one of many different errors, but it is most often due to an issue with the water or heat exchanger system.
The only problem is that this boiler has been plagued by an error 80 code, a software issue.
In a fix, Viessmann was able to resolve this issue, and even though they have not found the root cause of the error code, they were able to make it so that error 80 is no longer occurring.
This error code can be triggered when there are insufficient heat exchangers or water supply, which a blocked condensate drain pipe can cause.
“Inspections, Installations, Repairs & Maintenance”